NAIL CORRECTION + MODELLING

For sliding and pressing on the GOLDSTADT professional or spring-loaded brace. Length: 12 cm

The newly developed curved hook spatula serves two purposes. The curved hook is used to twist the ORTOGRIP loop and the spatula end is used to apply the covering of 2-component plastic. This tool is made of the best stainless steel to RUCK's high quality standards.

For sliding the GOLDSTADT professional or Spring Brace into position and distributing the nail mass.

RUCK® NAIL CORRECTION cleaner is used for the essential preparation of the nail surface before every brace application. It is important for the nail surface to be free from grease and residue, especially before applying RUCK® NAIL CORRECTION activator and adhesive. The cleaner does this gently but thoroughly.

For flattenting and deburring the wire ends. Perfect forged and hardened. 6 x 6 x 2,3 cm

Orthosis Nail Correction uses flat, pliable spring clips that do not require a centre loop / omega to correct them.

For fixing the Goldstadt Brace to the body of the nail. The gel-like consistency prevents run-off and gives quick hardening times of just a few seconds.

Ø 32 mm, Hight: 30 mm Ideal for mixing powder and hardener liquid.

Material residues can be removed easily after usage of the bowl.

Helpful when adjusting the clasp to the nailform

12,5/12,5 cm Prefabricated nail plate made of transparent plastic. With cold formable material, it is easy to prepare a fitting nail plate with scissors and round- nosed pliers.

Plaster Bowl made of natural rubber for mixing plaster.

Spatula for mixing plaster, silicone or hot wax. 20 cm long

Length 12 cm, pointed / smooth For adjusting the brace to the body of the nail and for bending the end-loops. For ORTOGRIP and GOLDSTADT braces, spring braces and brace wire up to 0.5 mm thick.

Length: 12.5 cm, baking smooth For bending and adapting corrective braces, in particular the GOLDSTADT professional brace.

Spatula for stirring and distributing the nail mass and for building up plaster models.

For holding wire braces, especially when tapping in the end-loops. Highest quality stainless steel, with extra-compacted surface

Fine, angled spatula with many applications. 17,5 cm long

Length: 13.5 cm, jaws short / grooved For adjusting the brace to the body of the nail and for bending and pressing the end-loops together.

Length 13 cm, pointed Extremely pointed (tip diameter, approx. 0.5 mm). For the finest work on nail correction, specially for bending end-loops with small radius and for processing the end of the VHO-Osthold brace. Suitable for all wire thicknesses. With reset spring.